Anyway to soften the water edges?

[Meical]

I'm not very experienced with OpenMW or with shaders in general. But I was hoping there was a setting somewhere that allowed me to soften up the edges of the water shader. Any help would be appreciated.

[Thunderforge]

Do any of the config file settings for water address what you are looking for?

[Meical]

None of these settings effect the water edge, that I've noticed. I've been tweaking the settings in the water_fragment.glsl file. However, I have not seen any of those settings make a difference with the water edge either. I'm not a coder or anything, just an amateur modder. But I am able to follow directions if given.